Part number: 006-0340-003
步骤1：开箱
确认您的货物是否齐全
| QTY |
Description
|
| 1 | ProSwitch 设备 |
| 1 | 以太网线 |
| 1 |
M4接地线
|
确认您所需要的软件：可从哈雷公司或代理商处获得
步骤2：识别您所需要连接的接口
类型A
类型B
| 主电压 | 100 VAC to 240 VAC |
| 电源类型 | 50 Hz to 60 Hz |
|
最大输入电流
(normal mode)
|
0.5A ‐ 0.25A 两个电源一起运行 |
|
最大输入电流
(default mode)
|
每个输入电源输入0.9A ‐ 0.45A 其中一个故障 |
| 隔离等级 | 1 |
步骤3：安装您的设备
A. Removing the protecting film
Remove the protective film from both sides before installation.
B. Rack mounting
The product can be mounted in a 19" rack.
- Ensure that it is firmly and safety located.
- Do not use this product to support any other equipment.
C. Connecting the system I/O ports
1. Connect the upstream and downstream devices:
- ASI platform: to the INx and the OUTx connectors respectively.
Note: Outputs 1, 3, 5 and 7 are smart secured outputs and must be connected or equipped with 75Ω stubs, if not, some input synchronization problems may appear, resulting in invasive switching.
- IP platform: to the Ethx connectors.
2. Connect the supervision network to the ETH 1 C/C connector.
3. If required, connect the GPI triggers.
4. If required, connect the free voltage contacts (relays).
D. Powering on the device
1. For both power supply units, plug the AC mains power supply cord to the power supply end and to the ProSwitch end.
2. Wait a few seconds while the platform runs self-tests to check the hardware.ackin
E. Setting the supervision IP address
1. Access the Command Line Interface
a. Open an SSH connection with the remote device.
You can use putty to open a SSH session on the equipment, using the
default factory IP address of the supervision interface (192.168.1.1).
b. Enter the Service credential (login : service, password :
ProSwitch=HLIT01)
2. List of commands available in CLI interface
a. Type help then press ENTER to display all the commands available.
3. Change the IP information
a. Type getIpInfoCmd1 then press ENTER
Display the current IP Cmd1 address setting
b. Type setIpAddressCmd1 XXX.XXX.XXX.XXX then press ENTER
Set the Management IP address
c. Type setIpNetmaskCmd1 XXX.XXX.XXX.XXX then press ENTER
Set the subnet mask
d. Type setIpGatewayCmd1 XXX.XXX.XXX.XXX then press ENTER
Set the Gateway IP address
4.Reboot the ProSwitch
a. Type reboot then press ENTER
The new IP parameters are set.
F. Starting the Application
1. Start your Web browser on your supervision PC.
2. Enter the IP address of your ProSwitch equipment in the address bar.
3. Click on the button « CLICK TO RUN ».
The download of the supervision interface starts (Java applet)
4. In the displayed security certificate dialog, click Always to use all the
functionalities of the ProSwitch product
步骤4：配置您的设备。
Device
Product
Solution
Brand
Techhub