Currently, the industry widely uses the Hailey ELP1000 (formerly Scopus UE9000) and Hailey PVR2900 (formerly SCOPUS IRD2900) for point-to-point live broadcasting, utilizing various transmission media. Typical cases include audio and video transmission for the Ministry of Railways and audio and video transmission for television shopping channels. Here, we will mainly introduce the encoder setup operations for audio and video transmission using IP/E1 channels for your reference. The following text is provided by Feng Lei.fenglei@onebandsys.comProvide.
1. Configuration of the ELP1000 UE9000 Encoder:
The front and back panel diagrams are as follows:
The encoder's front and rear panels are shown in the image above. In the new version of the hardware, the IP output and serial port will differ, please drive according to the actual traffic conditions :)
System Connection:
1. Connect the network management interface and the MpegOIP output to the network switch.
2. Connect the video input to the analog video input (or SDI) on the left side of the back panel.
3. Connect the audio input to the audio input interface in the middle of the back panel, using a XLR connector. (Embedded audio can use only SDI.)
System Configuration:
Device Management IP: Front panel config---unit----system--Ethernet set IP address to 192.168.101.X (X is a variable, refer to the attached table for specific information), subnet mask is 255.255.255.0, and the management IP is uniformly set to 192.168.101.254; after making changes, press the F1 key on the front panel and follow the prompts to save.
Set Audio Parameters
Set AUD2, AUD3, AUD4, etc. Activation to disable (off)
Set AUD1 Source to Analog or Embed (embedded digital video)
Set AUD1 Output Rate to 192kbps
Set Video Output Parameters
Set Video Input Source
Set VIDEO 1 Activation to enable
Set VIDEO 1 Source to CV (analog) or SDI (digital)
Set VIDEO 1 Format PAL
Set output rate 4000000 4Mbps
Set Video Profile 4:2:2 or 4:2:0
Set transport stream output parameters
Set output bitrate to 500000 5Mbps
Set service
Click on first service to enter settings, keep only 1 Service, delete any extras
Change the Service name to the local name
Check Video 1 and Audio 1, ensuring no other items are checked.
Set Output IP parameters
Set Activation to enable
Set Node IP to 192.168.100.X (please refer to the attached table)
Set Node Gateway to 192.168.100.1
Node UDP 5000
Destination IP Address 226.1.1.x (X see attached table)
Destination UDP port 2000
FEC Activation Disable
Please follow the above steps in order; save the configuration after each page operation.
You can use the Preset to save as a file for future system recovery.
2. PVR2900 IRD2900 Decoder Configuration
The rear panel diagram is as follows:
The top left corner of the backplane is the IP input interface.
The bottom left corner of the backplane is the network management control interface.
Local network management control.
Front panel.
Config-----unit------Ethernet—
Set the IP address to 192.168.101.X (X is a variable; refer to the attached table for specific information), with a subnet mask of 255.255.255.0, and the unified management IP as 192.168.101.254.
Confirm input board.
Config ----stream---source-----------IP front end.
Confirm input signal.
Config---Receiver---MPEGoIP input 1
Operation enable
IP address 192.168.100.X
MASK 255.255.255.0
Default Gateway 192.168.100.254
Logical Source
IP address type multicast
IP Multicast 235.1.1.1
UDP Destination port 2000
Dear all, that concludes my presentation. If you have any questions, please contact our technical department or maintenance department, or reach out to the author directly via email.